This gearbox is manufactured from a solid block of Dural EN AW 7075 T651 aluminum, which has higher strength (590MPa) than common construction steel (390MPa). Retro Arms gearboxes have better durability and resilience than common zinc-aluminum gearboxes as found in most Airsoft guns.
This gearbox also features a quick change spring system QSC, which allows you to change the spring without opening the gearbox.
|
Features
- Made from Aircraft grade Dural EN AW 7075 T651 aluminum
- Anodized black for corrosion resistance
- Compatible with VFC ambidextrous selector switches
- Threaded post for re-using your VFC's bolt release latch
- Grooved spring holders, so the tappet and trigger trolley springs will not jump off
- Added groove for safety lever
- AOE control hole
- Sockets for bushings / bearings are 0.02mm (7.98mm) smaller to prevent the bushings / bearings from spinning and falling out
- Wiring grooves enlarged by 1mm; wire up to 2.5mm diameter can be used
- Added protective edge for wiring by the motor shaft area
- All threads are now shaped instead of cut for better strength
- Both of the gearbox halves are centered by milled grooves and edges
- Added hole for releasing anti-reversal latch
- For better durability, additional material was added around the cylinder head area
- Radiused cylinder windows
- Added groove for anti-reversal latch spring, so it will not jump off
- Outer edges are chamfered
|
Includes
- CNC Ver. 2 Gearbox (VFC Spec.)
- Steel ball-bearing QSC spring guide
- Set of screws
- For use in VFC spec. Airsoft guns only
- Note: do not use MAXX CNC cylinder heads!
|
